Description

I wanted a good gaming pc and Im happy with the results. I choose the parts with the help of pc parts picker and it helped with seeing different variation I can do for a new pc. I chose certain parts due a limited budget,For example I wanted a Samsung 950 which was way to expansive for me. Im happy with the Samsung 850 and how it doesn't use cables(sata etc.) and is tucked away behind the mother board.Also picked a reference 980 Ti because the tight space and wanted make sure it wasn`t near the H100i cooler. The only complaint is with the Corsair link and interface is more flash then function.

Comments

  • 44 months ago
  • 1 point

nice! could do with some more pics though!!!! +1

[comment deleted by staff]
  • 44 months ago
  • 1 point

+1 very clean

  • 44 months ago
  • 1 point

I was wondering where the drives were, until I saw the M.2 drive behind the motherboard. Great build!

  • 44 months ago
  • 1 point

how are GPU temps ? +1 for nano s ! :D

  • 44 months ago
  • 1 point

so far the temps have been in the range of 40C to 65 C with out any overclocking.

  • 44 months ago
  • 1 point

Nice rig. I'm working on a similar setup but I'm a bit confused with the fans. I have a back exhaust fan, and then the corsair radiator in the front with two fans. The instructions say it should be sucking air in - but then the fans would be sucking in the warm air from the radiator into the case? Is that how you have it setup or are you blowing air out the front?

Any input would be appreciated.

  • 42 months ago
  • 1 point

I think theirs a few factor than will effect this,One would be climate/ambient room temperature,CPU or GPU overclocking.As for orientation of the fans I would think it depends on what you prefer for positive and negative pressure case ariflow.

[comment deleted]
  • 34 months ago
  • 1 point

I would definitely have the radiator fans mounted as intake (through the radiator) on this case... the two filtered panels (front and bottom) are perfect intake zones, so take advantage of these to create a slight positive pressure (keeps air gently escaping the other holes to keep the inside generally dust free.

Also you have to remember, it's sucking cool air from outside into the radiator this way, which is better for CPU-cooling than blowing warm interior air through the radiator to vent to outside. Your ambient temps may raise a degree or two, but the CPU will remain nicely cooled!

I have the h100i v2 drawing from the front (Noctua iPPC fans), another intake on the bottom, and a 1070 Hybrid radiator/fan venting to the rear.

[comment deleted]
  • 36 months ago
  • 1 point

Do you have your radiator fans set as intake or exhaust?

[comment deleted]