• Log In
  • Register


Upgrade for my 980 ti system

by Slowww



Date Published

Nov. 10, 2017

Date Built

Oct. 18, 2017

CPU Clock Rate

4.9 GHz

CPU Temperature While Idle

29.0° C

CPU Temperature Under Load

65.0° C


Moved from i5 4670k, 16gb ddr3 1600, 980 ti, custom loop cooling, to this.

8700k, msi godlike, 32gb ddr4 3200, 980 ti sli (picked one up used for $340.00 with waterblock), upgraded custom loop

Comments Sorted by:

_Unphazed_ 2 Builds 1 point 14 months ago

Nice build. What kind of fans and res/rad is that?

Slowww submitter 2 Builds 2 points 14 months ago

Thanks, it's a switch h320 x2 prestige cooler. It comes with 3 eloop noiseblocker 120 fans that i mounted on top rad and back. Front rad is 3 corsair LL120 rgb fans.

Drente 1 point 14 months ago

Swiftech X320/Alphacool st30 240mm

Ele405 1 point 14 months ago

Can't get enough of white and red builds. Looks amazing

the_naked_nerd 8 Builds 1 point 14 months ago

Nice one next upgrade maybe hard line ?

Evan.K 1 Build 1 point 14 months ago

Are those CableMod wires? If so ModMesh or ModFlex? I'm looking for some ModMesh combs, but can't seem to find any in the US.

Slowww submitter 2 Builds 1 point 14 months ago

Yes, they are CableMod. I believe they are modflex. Have you checked Microcenter online store?

Tiger_Woods 1 point 14 months ago

Looks like Christmas inside

mjk37 1 Build 1 point 14 months ago

Nice build Think I am going to do something similar any chance you could tell me what the slot spacing for the SLI bridge is because I wanna get the EVGA HB bridge but don't know what size to get.

And any clearance issues with that motherboard?

TruVueTech 3 Builds 1 point 14 months ago

Don't want to hate on your cable management but if you run the GPU power cables into the back of the system and out of the lower black rubber grommet you can get a cleaner look with the cables running straight out and then bending up and down to connect to the GPU's. (you can look at picture 2 from my build for reference on what i am describing) that is really just an idea. other than that really sweet build. Oh, thank you for the well though input on my build as well man.

ryanduffy1990 1 point 13 months ago

Did you have any clearance issues with the deeper Z370 board and ATX FF of the case? I really like both but am concerned re. the above!!! :'(

Slowww submitter 2 Builds 1 point 13 months ago

No, the edge of the board slightly covers the rubber grommets for cable routing but they are still fully accessible.

deathcycle91 1 point 12 months ago

How is the MOBO doing so far ?

Slowww submitter 2 Builds 1 point 12 months ago

No problems at all. Needed a bios flash before my xmp profile would work, but other than that its been great.

deathcycle91 1 point 11 months ago

Awesome, been looking into it myself. +1 love that loop :D