Description

I built recently, and this would make this computer my 2nd custom build. The only problem I had was routing my CPU power cable, as it was too short to go through the rubber holes behind the motherboard tray, and then turn and run to the CPU socket. Instead, it just goes its own way straight down through my hardware and into the connector. Also, the tubes on the cooler are under quite a bit of tension because it was quite hard to get the cooler to mount securely. Overall it was a very smooth experience building it, I set it up with Windows and drivers in no time, and I'm very happy with its performance in games.

Log in to rate comments or to post a comment.

Comments

  • 48 months ago
  • 1 point

Very good balance. The h100 wasnt necessary though. a Cyroig C7 would have been fine. a better and more reliable kit of ram would have been nice too. The good balance comes in with the Fx 6300 and R9 380. One wont be bottlenekcing the other and u will have great performance in games

  • 48 months ago
  • -1 points

its not very balanced at all. I made a rig for $600, i5 + r9 380, that performs better than this (exluding peripherals and OS).

  • 48 months ago
  • 2 points

The FX6300 and R9 380 show balance. the FX 6300 performs around equal with the i5 in games

  • 48 months ago
  • 1 point

That case is amazing! OuO nice build

  • 48 months ago
  • 1 point

It looks nice. You could use a few more pictures.

You probably should get that up off of the ground. Off of the carpet would be great. It is an expensive vacuum cleaner down there. Even putting it on a 1 inch thick board the length and width of the PC would be great. It would give you more clearance, better air flow and less dust accumulation.

  • 47 months ago
  • 0 points

Hey there! Would you mind doing me a favor and measuring the bottom inside of the case from the front to the back where the 360 radiator mounting location would be? Also, can you please measure from the inside bottom left up to the bay shroud where the 2 intake fans are?

I'm trying to determine if this case is capable of running a 280mm radiator in the front and a 360mm radiator in the bottom at the same time. Thank you!

[comment deleted]