PCPartPicker

  • Log In
  • Register

Comments

Endest's Completed Build: Darling In The Franxx

Endest submitter 1 Build 1 point 4 months ago

That's a Bitspower Case Top Water Fill/ Through Hole Fitting, the model is: BP-DWWP-C04

Endest's Completed Build: Darling In The Franxx

Endest submitter 1 Build 1 point 4 months ago

sorry saw i completely misread your question, they're 200mm reservoirs.

Endest's Completed Build: Darling In The Franxx

Endest submitter 1 Build 1 point 4 months ago

Hi thank you! the LED strip is from Dazmode - Dimmable Rigid LED Strip V2 but any led strip would work for this to be honest. The white plate is just an acrylic plate with low opacity.

Endest's Completed Build: Darling In The Franxx

Endest submitter 1 Build 2 points 5 months ago

Idle: CPU - 30 (with OC to 4.4 Ghz) GPU - 26

Load: CPU - 48 - 56 (gaming for several hours to running concurrent virtual machines and high amount of computations) GPU - 42 -44

Endest's Completed Build: Darling In The Franxx

Endest submitter 1 Build 1 point 5 months ago

Added a pic of the back tubing that I did while completing the build, hopefully that helps so you can see how the loop is done.

Endest's Completed Build: Darling In The Franxx

Endest submitter 1 Build 1 point 5 months ago

yeah saw it this morning, super stoked :)

Endest's Completed Build: Darling In The Franxx

Endest submitter 1 Build 1 point 5 months ago

they are Black Ice Nemesis 360GTS Ultra Stealth U-Flow Low Profile Radiators to combat the limited space, as otherwise I'd have had even more space issues with the tubing and the through put holes on the top side, as well as space issues with the reservoirs and the GPU. I already had to modify the GPU to fit with the current setup.

I will try to add some images from the rear in the next few days.

Endest's Completed Build: Darling In The Franxx

Endest submitter 1 Build 1 point 5 months ago

Hi, this build only uses exhaust fans without any heat issues, so far I'm only running an overclocked CPU and neither the CPU nor the GPU exceed 48 degrees celsius under full load. If temperature becomes a problem in the future I have 2x 140 (cryorig XT140) super slim fans that can be mounted on the bottom of the case and push air inside, as the bottom of the case is perforated with a lot of air holes and the case sit's about 1-1.5 inch above the table. If this would be a single loop I'd have used intake fans, but as they're two separate loops it seems to be doing very fine.

Endest's Completed Build: Darling In The Franxx

Endest submitter 1 Build 1 point 5 months ago

Yes, a couple of small modification included covering up all cable passthrough holes with white acrylic, so that I could only have cable sized holes for the cables as well as drilling 4 holes in total for the water cooling pass through.

Page
1